Tips for DIY Tree Removal

Tree removal can be very dangerous and also life-threatening. It really is never recommended to eliminate a tree all on your own unless it is just a small one that you are confident you can handle safely. Otherwise, tree removal ought to be left in the hands of professionally-trained and equipped tree service contractors. When you have a tree on your own property that's fairly small, but must be removed, it is possible to possible do it yourself with the right tools, knowledge, and planning.

Tree Removal Preparation

Proper preparation for small tree removal involves gathering all your needed supplies, and, a comprehensive inspection of the tree. Look to see if the tree leans a proven way or the other, and plan a getaway route in case it does not fall how you expect it to fall. Also, examine whether you can find any obstacles in any direction of the tree, including vehicles, structures, and other trees. When you are sure there's enough safe clearance for the tree to fall, then you can move ahead to gathering your equipment and tools. This includes:

Safety Gear (Utility gloves, goggles, hard hat, steel toe boots, etc.)
Chainsaw
Ax or Hacksaw
Ladder
Rope
Wedges
First Aid Kit
TO ELIMINATE a Tree

Once you have all your equipment and supplies, you may get started removing the tree. First, use your ax to knock on the bark a few times, and in several different places, to understand how solid or hollow the tree is. Getting a less dense area to cut will be easier. Next, plan which side of the tree you need to make your cut. Turn to see where in fact the tree naturally leans; it is best to cut a tree in the direction where it really wants to naturally fall. Be sure the area where the tree drops is level therefore the tree does not roll or bounce after it falls.

Make a horizontal cut at hip-height, and about 1/3rd in to the tree. Do this on the side of the tree where you want it to fall. If you want the tree to fall to the proper, you must make you cut on the same side so it falls inward, towards the cut. The tree will fall perpendicular to your horizontal cut. Your second cut should create a wedge into the tree. So make the next cut at an angle from the initial cut. It should look like a lemon wedge.

Visit the website  is called a back cut, and is ought to be made on the opposite side of your wedge cut. This cut will make the tree fall over on the side of one's wedge cut. Make it about 1.5 inches above the wedge cut, and as thick as possible. You can even use a wedge to avoid the tree from settling onto the chainsaw. Add more wedges as necessary before tree begins to fall. Then run! But do not turn your back on the tree as it falls.